PTC Creo on M1 Mac (ARM-based)

[noah02]

Hi,
Is someone using ptc creo on his M1-Mac via Parallels? Is it working or are there any issues?

Thanks for your response in advance!

 

[MOUHSINES]

I just tried now. It is not working. I could install creo8 on my M1-Parallels, with no errors/issues. But when i try to start Creo, nothing happens (no messages, etc.).
In parallel, i installed and I am able to run SolidWorks.

 

[LutherB]

I just tried now. It is not working. I could install creo8 on my M1-Parallels, with no errors/issues. But when i try to start Creo, nothing happens (no messages, etc.).
In parallel, i installed and I am able to run SolidWorks.

Check out this post: https://forum.parallels.com/threads/solidworks.353226/ The process illustrated there might help. I have heard of people running Creo without issue, so it's likely something you'll be able to fix.

 

[Maria@Parallels]

Hi,
Is someone using ptc creo on his M1-Mac via Parallels? Is it working or are there any issues?

Thanks for your response in advance!

Hi, if you tested it and got any issues please share the details here.