Parallels 10 crash dump while convert VMware Fusion 7 VM
- Thread starter nikeitan
- Start date
Hi Nikeitan,
Please follow the steps suggested at kb.parallels.com/115305 and check how it works.
Please follow the steps suggested at kb.parallels.com/115305 and check how it works.
Intent_Media
Bit poster
Hi Support,
I've run into the same issue. I am unable to convert a vmware 7 vm to Parallels 10. I get a 41300 error. I've tried every kb instructions to convert it but hasn't worked.
I've tried via CLI using these commands:
/Applications/Parallels\ Desktop.app/Contents/MacOS/prl_convert /<path to .vhd> --no-src-check --no-reconfig
/Applications/Parallels\ Desktop.app/Contents/MacOS/prl_convert /Volumes/500gb\ 1/WIN-8.VHD --no-src-check --no-reconfig
None of these worked. Any other tips to make this happen?
I've run into the same issue. I am unable to convert a vmware 7 vm to Parallels 10. I get a 41300 error. I've tried every kb instructions to convert it but hasn't worked.
I've tried via CLI using these commands:
/Applications/Parallels\ Desktop.app/Contents/MacOS/prl_convert /<path to .vhd> --no-src-check --no-reconfig
/Applications/Parallels\ Desktop.app/Contents/MacOS/prl_convert /Volumes/500gb\ 1/WIN-8.VHD --no-src-check --no-reconfig
None of these worked. Any other tips to make this happen?
Abdul@Parallels
Parallels Support
Hi Intent_Media,
Please follow the steps as suggested at http://kb.parallels.com/112419 and let us know how it goes.
Please follow the steps as suggested at http://kb.parallels.com/112419 and let us know how it goes.
Intent_Media
Bit poster
Hi Abdul,
Thanks! Will do.
Thanks! Will do.
Hi Intent_Media,
You're welcome. Try following the steps suggested at the knowledge-base article and let us know if the issue still persists.
You're welcome. Try following the steps suggested at the knowledge-base article and let us know if the issue still persists.
John_Haupt
Bit poster
I followed all steps in the "resolution" section to no avail. I was able to convert my VMWare Fusion 7.0 image to Parallels 10 after I used the recommended terminal command.