When I start parallels up, the logo comes up on black screen and I get as far as 3 squares on the progress bar, then it hangs for several minutes (yes, minutes.) Eventually the logo screen goes away and I see the following:
* Reading files needed to boot ... [ OK ]
* Setting preliminary keymap ... [ OK ]
* Preparing restricted drivers ... [ OK ]
* Starting basic networking ... [ OK ]
* Starting kernel event manager ... [ OK ]
* Loading hardware drivers ...
udevd-event[3191]: run_program: '/sbin/modprobe' abnormal exit
[ OK ]
*Loading kernel modules...
*Loading manual drivers
I installed Feisty Fawn, then installed upgrades and then installed parallels tools. It booted up fine a few times, and then I started getting the above problems.
The two weird things I did when the OS actually worked, was start this tutorial (http://tinyurl.com/18r) (I don't think I had to, did I?) and then try to enable desktop effects.
Any suggestions?
* Reading files needed to boot ... [ OK ]
* Setting preliminary keymap ... [ OK ]
* Preparing restricted drivers ... [ OK ]
* Starting basic networking ... [ OK ]
* Starting kernel event manager ... [ OK ]
* Loading hardware drivers ...
udevd-event[3191]: run_program: '/sbin/modprobe' abnormal exit
[ OK ]
*Loading kernel modules...
*Loading manual drivers
I installed Feisty Fawn, then installed upgrades and then installed parallels tools. It booted up fine a few times, and then I started getting the above problems.
The two weird things I did when the OS actually worked, was start this tutorial (http://tinyurl.com/18r) (I don't think I had to, did I?) and then try to enable desktop effects.
Any suggestions?