pls help..

when installing w10 I always get this message about firmware and uefi, I can't figure out where to enable it .. installation of w10 fails, can't start .. so please advise what to do with it, i have the latest version of parallels pro..

pls help..

 

Hi, in the screenshot the error message is in your native language. Kindly translate it in English over here so that we can understand the issue better and help you out.

 

The secure boot feature prevented the operating system from starting. Secure Boot has detected unauthorized changes to the firmware, operating system, or UEFI drivers. You can manage secure boot settings in the virtual machine configuration. Click on the hardware and expand the advanced settings section.

Installation of windows 10 arm, macbook M1 for max 14 "arm 2021

 

Hi RadoslavV1, this issue was discussed here

 

Hi, Windows 10 will not support on Mac M1 chip, because windows 10 is not ARM-based.

 

ok thanks

 

Hi, we are happy to assist you. Please reach us back for any further queries.

 

Hello,

I am experiencing an issue with Parallels Desktop on my Mac.

My virtual machine running Windows 11 was working normally until yesterday. However, today it fails to start and shows the following error:

"The Secure Boot feature prevented the operating system from starting. The Secure Boot policy settings in the firmware could not authenticate the code. Check the Secure Boot policy in Setup."

I did not make any manual changes to the virtual machine configuration. The issue appeared अचानक (possibly after an update or system restart).

I have checked the VM configuration, but I cannot find or modify the Secure Boot setting.

Could you please assist in resolving this issue?

Thank you.