autocad nudge command

Discussion in 'Installation and Configuration of Parallels Desktop' started by PatrickL2, Dec 15, 2015.

  1. PatrickL2

    PatrickL2 Bit poster

    Messages:
    1
    I have paralells installed on my MacBook pro with retina display. There is a command in autocad called nudge where you hold the cntl key down and press the directional arrows to "nudge" an object in the direction of the arrow. How do I enable the control key as the cntl key or reassign a key to perform as the cntl key?
     
    PatrickL2, Dec 15, 2015
    #1
  2. Ram@Parallels

    Ram@Parallels Parallels Support

    Messages:
    759
    Hi PatrickL2, Please go to the Parallels Desktop menu > Preferences > Shortcuts tab > System Shortcuts > set 'Send System Shortcuts' option to 'Always'.
    Restart Virtual Machine > Use Ctrl key and let us know how it goes.
     
    Ram@Parallels, Dec 17, 2015
    #2
  3. Maria@Parallels

    Maria@Parallels Problem solver

    Messages:
    8,115
    Hi, could you please provide us with the problem report using this KB. Please generate it right after the issue reproducing.
    Also please provide us with version of the Autocad application.
     
    Maria@Parallels, Dec 17, 2015
    #3
  4. Ram@Parallels

    Ram@Parallels Parallels Support

    Messages:
    759
    Hi, could you please provide us with the problem report using this KB ( http://kb.parallels.com/9058 ). Please generate it right after the issue reproducing.
    Also please provide us with version of the Autocad application.
     
    Ram@Parallels, Dec 18, 2015
    #4

Share This Page