Unable to start Parallels services - Mojave

Discussion in 'Installation and Configuration of Parallels Desktop' started by MatthewH10, Sep 16, 2020.

  1. MatthewH10

    MatthewH10 Bit poster

    Messages:
    1
    updated my old Mac Pro 2010 to Mojave - was attempting to give Parallels 16 a go on the trial but I get a message "Unable to start Parallels services" everytime.

    Ive followed all the steps you've listed [ https://kb.parallels.com/124001 ] and even had a looked around the internet for solutions.
    In the end Found if I disabled SIP it installed and worked fine but ONLY while SIP was disabled as I do not want to do this I re enabled SIP which broke it again.

    Any ideas?
    In Security and privacy ive given full disk access and accessiblity, also added to firewall to allow all connections - still no joy.
    The version im installing is the lastest one ParallelsDesktop-16.0.1-48919.dmg
     

    Attached Files:

  2. Maria@Parallels

    Maria@Parallels Problem solver

    Messages:
    8,115
    Hello,
    could you please collect the tech report once the issue reproduced and post the report's ID here.
    Looking forward to your reply.
     
  3. Maria@Parallels

    Maria@Parallels Problem solver

    Messages:
    8,115
    Hey,
    please also check this thread and the answer from MichaelF27
     

Share This Page